How to add Tun/TAP/PPP/Fuse support

NOTE: This is for new Openvz/LXC plans only.

1. You need to login to web panel and click the Active Product you want to enable it on
2. If you see "Add Tun" button, click it (if not, it is already enabled), then continue to #3 below,
3. click Stop VPS button in web panel <----- DO NOT SKIP THIS STEP!!!
4. Click Start VPS
5. SSH to your VPS and type

mkdir /dev/net
mknod /dev/net/tun c 10 200
chmod 0666 /dev/net/tun
ip tuntap add mode tap
--show it
ip link

For PPP:

mknod -m 666 /dev/ppp c 108 0
service pptp restart

To actually use a tun/tap device it must be created inside the container on every boot, so add the following to your /etc/rc.local inside your container:

if ! [ -c /dev/net/tun ]; then
mkdir -p /dev/net
mknod -m 666 /dev/net/tun c 10 200
fi

Was this answer helpful?

 Print this Article

Also Read

How to install from ISO (New KVM)

This is only for our New KVM based VPS, there are 2 different New KVM plans, click here for KVM...

How setup OpenVPN on OpenVZ with Centos 6 64-bit template

This is only for New OpenVZ with Centos-6-OpenVPN-64-bit template. You can reinstall to this...

How to order Addons (extra rams/space/bandwidth)

1. Please login and go to to our client area products page2. Click "Active" button on the product...

Difference between OpenVZ and LXC

OpenVZ OpenVZ is a Linux container solution. It was first released in 2005 by SWSoft, now known...

How to resize/extend Windows or Linux disk space (LVM)

If you buy a plan with more than 15GB of disk space, the remaining space is empty and need to be...