How to add Tun/TAP/PPP/Fuse support

NOTE: This is for new Openvz/LXC plans only.

1. You need to login to web panel and click the Active Product you want to enable it on
2. If you see "Add Tun" button, click it (if not, it is already enabled), then continue to #3 below,
3. click Stop VPS button in web panel <----- DO NOT SKIP THIS STEP!!!
4. Click Start VPS
5. SSH to your VPS and type

mkdir /dev/net
mknod /dev/net/tun c 10 200
chmod 0666 /dev/net/tun
ip tuntap add mode tap
--show it
ip link

For PPP:

mknod -m 666 /dev/ppp c 108 0
service pptp restart

To actually use a tun/tap device it must be created inside the container on every boot, so add the following to your /etc/rc.local inside your container:

if ! [ -c /dev/net/tun ]; then
mkdir -p /dev/net
mknod -m 666 /dev/net/tun c 10 200
fi

Esta resposta lhe foi útil?

 Imprimir este Artigo

Veja também

How to order Addons (extra rams/space/bandwidth)

1. Please login and go to to our client area products page2. Click "Active" button on the product...

How setup OpenVPN on OpenVZ with Centos 6 64-bit template

This is only for New OpenVZ with Centos-6-OpenVPN-64-bit template. You can reinstall to this...

How to enable and setup RDP on Windows

NOTE: This is done on Windows 2012 DC R2 edition, other versions might be slightly different.1....

How to install from ISO (New KVM)

This is only for our New KVM based VPS, there are 2 different New KVM plans, click here for KVM...

How to install virtio disk driver for Windows install

First you go to "NoVNC Console" in web panel to access console and start your windows ISO...