How to add Tun/TAP/PPP/Fuse support

NOTE: This is for new Openvz/LXC plans only.

1. You need to login to web panel and click the Active Product you want to enable it on
2. If you see "Add Tun" button, click it (if not, it is already enabled), then continue to #3 below,
3. click Stop VPS button in web panel <----- DO NOT SKIP THIS STEP!!!
4. Click Start VPS
5. SSH to your VPS and type

mkdir /dev/net
mknod /dev/net/tun c 10 200
chmod 0666 /dev/net/tun
ip tuntap add mode tap
--show it
ip link

For PPP:

mknod -m 666 /dev/ppp c 108 0
service pptp restart

To actually use a tun/tap device it must be created inside the container on every boot, so add the following to your /etc/rc.local inside your container:

if ! [ -c /dev/net/tun ]; then
mkdir -p /dev/net
mknod -m 666 /dev/net/tun c 10 200

Was this answer helpful?

 Print this Article

Also Read

How to fix NoVNC Console Just Black Screen

Debian 5,6,7 This will also work in debian8 if you use sysv-init instead of systemd Editing the...

"Server refused to allocate pty" on New LXC template(s)

NOTE: This seems to happen only on OpenVZ template(s) that's used on LXC, like Cenots 6 32-bit....

How setup OpenVPN on OpenVZ with Centos 6 64-bit template

This is only for New OpenVZ with Centos-6-OpenVPN-64-bit template. You can reinstall to this...

How fix Debian or Centos or Ubuntu console just black screen

If you have Debian or Centos or Ubuntu and when you go to NoVNC Console in web panel, you get...

How to install virtio disk driver for Windows install

First you go to "NoVNC Console" in web panel to access console and start your windows ISO...